Make sure the intersection snap is turned on, as we will need to snap to the intersections of our lines and rectangles. Now let's draw our two wall pieces using the Wire tool.Check that all the construction geometry has been placed into a "Construction" group, which makes it easy to hide it all at once or even delete it completely later on. That is all we need now, so we can switch construction mode off.Give each new copy any start point, you can leave it at (0,0,0) for example, and the following relative endpoints: Perform each move operation in sequence on the line that was created immediately prior. Turn also the Relative mode on, which will allow us to define movements in relative distances, which is easier than calculating the exact position of each line. Duplicate that line 5 times, using the Move tool with Copy mode turned on.Draw the first line from point (15cm, 1m, 0) to point (15cm, 3m, 0). The crossing of these lines with our two rectangles will give us useful intersections to snap our walls to. We can then draw a couple of vertical lines to define where our doors and windows will be placed, using the Line tool (note that the "relative" mode box should be unchecked for this step).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |